Jump to content


Photo

Terrorist Nodes


  • Please log in to reply
1 reply to this topic

#1 j'ordos

j'ordos

    Alien Concept Task Force

  • Xenocide Artwork Department
  • 5,059 posts

Posted 12 September 2004 - 03:36 AM

So, I made a new terror ship map, and I wanted to use specific spawn points and nodes for terror units. So I looked at the original terror ship, but they apparently they only use soldier spawn nodes for terror units, so they're used by both soldiers and terrorists. This, however, was not what I had in mind, as I wanted different locations and routes for terror units and soldiers. One way could be by making a separate set of nodes set to 'large' units only, but then chryssalids, silacoids and celatids will not use them, and instead use the soldier nodes for 'small' units, like the regular troops would do. Now, is there any way I can designate nodes specifically to terror units, or is that impossible?
"You can't trust your eyes if your imagination's out of focus" - Mark Twain
"The mind is like an umbrella, it functions best when open" - Walter Gropius
Posted Image
SNEKK BLOG U-LAR MEKHH! GAHGHH! RK!
GRRGH RGGHH SNORRTT GHACKHGG

Now presented in DoubleVision™ (where drunk)

#2 Hobbes

Hobbes

    UFO2000 Staff

  • Moderators
  • PipPipPipPip
  • 719 posts

Posted 12 September 2004 - 10:26 AM

I don't think that's possible for the small terrorists. :(

Like you said, you can use the Large flag for the Sectopods and so on but there's no equivalent for the smaller units.